Electronics Job List for the Start of Run II

---

• CDF_CLK and TDC_CALIB Termination modification for crate backplane - Roberto, Orlando
• Still need to do teststands in B0: Calorimeter, TOF, COT Cleanroom, Muon Trigger
• Need to make sure all Testclk modules are modified like TRACERs
• Task description:
• Remove TRACER and replace with modified board that has termination  resistors on CDF_CLK and CDF_CLK* also on TDC_CALIB and TDC_CALIB*
• Remove transition cards from rear of crate for slots 1-5 and 18-21.
• Remove termination SIPs from rear backplane and replace with modified SIP
• Test that termination is 50 Ohms
• Detector Infrastructure
• Separate 400 Hz and 60 Hz control from Slow Controls
• Provide separate "Off" buttons for each in IFix (I&I + Duane) - In progress
• Install crate(s) for Forward Detectors (Feb?)

 
• Counting room infrastructure:
• Trigger room Halon - I&I
• Power supply assembly/testing/installation
• Convert two Model 1 Alacrities to become Model 5 - Roberto (Jan-Feb in progress)
• Spare will be adusted as model 5a (high current -5.2V)
• Convert one Model 1 Alacrity to become Model 4 - Roberto (Feb after Model 5s)
• Assemble 2 Vicor supplies for CLC and Calorimeter Calibration crates- Roberto (Feb)
• Assemble a test load for Vicor supply - Roberto (Feb)
• Assemble power supply harnesses for CLC, Calorimeter Calib and Forward detector crates - Rene or Orlando (Feb)
• Install all of above
• Rabbit Power supply repair (John Bell + Roberto?)
• Inventory of C supplies
• Cable assembly/repair work:
• MVME712 module flat cables - Redo DAQ VRB
• Cable Dressing/redressing
• Rework HADASD -> Patch Panel cables  (Orlando + Shift crew?)
• Replace latches with screws at patch panel
• Calorimeter Calibration crate - CHA/WHA Laser Reference PMT cables reach
• Cables will need to be 50ft long
• Need 2600 ft of RG174 + 26 lemo + 26 Radial connectors
• Will need 1 HADASD transition board + 2 ADMEM transition board
• Diagnostic ethernet for FIB and Plug racks (Feb)
• Reconfigure DAQ VRB racks for reset module (Roberto)
• Hadron ASDs:
• Modify power supply filtering -
• Add bypass caps
• Install ASDs - Rick
• Install patch panels and Patch-panel to TDC cables (with above cable rework) - Orlando + Helper - Feb
• Install Trigger Inhibits patch panel and test inhibits (JDL)
• Power Supply monitoring installation and checkout:
• Central Detector Power supply and monitoring debugging (Rene, Roberto, Duane) - Feb-March
• Install long Cables for SVX FIB and Muon (Dervin)
• Local Cabling and boxes for CMP/CMX/IMU and FIB racks - Rene + Duane
• Clock fanout crate monitoring - JDL + Chappa
• Work on electronics storage - need more crates
• Set up teststand area on 2nd floor
• Need room layout
• Add one more Trigger crate
• Install calorimeter teststand crate in 1RR30H
• Cut out side panel of rack
• Add rack protection to rack
• Remove 1RR30I and put in floor tile
• Install VIPA crate, SDM crate, NIM crate?

---

Updated by Peter Wilson 2/2/01