2/28/2000
							Steve Blusk

Hi Mike,

   Here is the orientation of the connectors which we used on the
junction board adaptor. As you are looking at the figure, the
cables are coming from from left to right.

I would like to suggest that we try and use this  orientation for
the following reasons:

1. The LV surface-mount connector has the highest profile, and so it should
be furthest in on the inner-board. We only have a total of 0.93" of
radial space between the top of the inner-board and the G-10 frame, so we
can't waste radial space.

2. The LV connectors have a lock-clip, which would not be easily accessible
if the pins 1-12 are on the large-|Z| side.


If you must change the orientation you should let me know asap, since
this could greatly affect the junction card support structure.


Steve